Blog

If you're having problems getting your boiler to start, it can be a frustrating and stressful experience. Fortunately, there are a few simple steps you can take to try and get your boiler running again. In this article, we'll cover the most common causes of boiler not starting and what you can do to fix them.

First, check the power supply. Make sure the boiler is plugged in and that the power switch is in the "on" position. If the power supply is fine, the next step is to check the pilot light. If the pilot light is off, you may need to relight it. To do this, you'll need to follow the instructions in your boiler's manual.

If the pilot light is on but the boiler still won't start, it could be due to a blocked flue. The flue is the pipe that vents the combustion gases from the boiler. If the flue is blocked, the boiler won't be able to draw in enough air to start the combustion process. You'll need to check the flue for any blockages and remove them if necessary.

If the flue is clear, the next step is to check the pressure of the boiler. Most boilers have a pressure gauge that shows the current pressure. If the pressure is too low, you'll need to top it up. You can do this by following the instructions in your boiler's manual.

If the pressure is correct but the boiler still won't start, it could be due to a faulty thermostat. The thermostat controls the temperature of the boiler and if it's not working correctly, the boiler won't be able to start. You'll need to check the thermostat and replace it if necessary.

If all of the above steps have been completed and the boiler still won't start, it could be due to a fault with the boiler itself. In this case, you'll need to contact a qualified engineer to diagnose and repair the fault.

In conclusion, if your boiler won't start, there are a few steps you can take to try and fix the problem. First, check the power supply, the pilot light, and the flue for any blockages. Then, check the pressure of the boiler and top it up if necessary. Finally, if all else fails, contact a qualified engineer to diagnose and repair the fault.